最佳回答：

紫外線照度計1401是一種高質量的UV能量測量?jī)x。其獨特設計的內置手把，在使用時更為方便。 融達紫外線照度計是用于測量不同光源的UV能量，尤其是用于印刷機器上。確保印刷及干燥之過程達到理想的質量控制。 能量計能測量的光譜范圍為 250-410納米，最佳感應 高峰光譜輸出為330納米。 當曝光循環時附加射入的光線 數量，相對的價值會計算在內。 由于光源不規律的放射分布，及不同制造商有不同的構造設計。以致在同一測量 條件下，可能出現不同的讀數。 使用方法： 1． 按下紫外線照度計之開關制“ON”，顯示屏上將顯示“0”。 2． 把紫外線照度計翻轉放在輸送帶上。（傳感器是安裝在儀器之背面，亦能抵受較高的溫度。） 3． 待儀器通過了輸送帶手，可從正面閱讀結果。 紫外線照度計顯示如：mJ/cm2 4． 在進行一個新的測量程序前，必須先把儀器關掉，然后再次開動。顯示屏上將重新調至“0”。 接著可依照2繼續操作。 注意事項： 1. 請避免搖動儀器。 2. 勿直視或非直視即通過折射/反射UV燈，保證身體的任何部位均不受UV燈直射。 技術數據: 光譜范圍： UV 250-410 nm(納米) 測量范圍： 0-5,000 mW/cm2(毫瓦特/平方厘米) 顯示范圍： 0-999,999 mJ/cm2（毫焦耳/平方厘米） 電 源： AAA電池 電 功 耗： 100μA 電池壽命： 正常操作使用一年 幾何尺寸： 140毫米直徑，13毫米高 凈 重 量： 約450克 環境溫度： 0至45度(攝氏℃) 瞬時溫度： 110（攝氏℃）溫度不可超過10秒。 調查校驗： 由于所有的電子原件，尤其是其燈光感應器，通常都會隨時間而老化，所以建議一年進行一次校驗。而且更換電池后，也應進行調查校驗。 According to 1401 meters UV is a high-quality UV energy meter. Its unique design of the built-in hand, more convenient in use. Melting of the UV meter according to the different light source is used to measure the UV energy, especially for the printing machine. To ensure that the process of printing and drying to achieve the ideal of quality control. Energy Meter to measure the spectral range of 250-410 nm, the best sensor peak output of 330 nanometer spectrum. When the exposure cycle the number of additional light into the relative value of the excluded. Irregular as a result of the radiation source distribution, and different manufacturers have different structural design. Result in the same measurement conditions, the readings may be different. Use: 1. Press UV system according to meters of the switch "ON", the display will show "0." 2. According to the ultraviolet light turned on the conveyor belt on the meter. (Sensor is installed in the back of equipment, can withstand a higher temperature.) 3. Through the conveyor belt to be hand equipment can be seen from the results of a positive reading. According to the UV meter shows such as: mJ/cm2 4. Conducting a new measurement procedure must first turn off the apparatus, and then start again. Will re-display to "0." Can then continue to operate in accordance with 2. Notes: 1. Please avoid shaking apparatus. 2. Do not open or open by refraction / reflection UV light to ensure that any part of the body are not subject to direct UV light. Technical Data: Spectral range: UV 250-410 nm (nanometer) range: 0-5,000 mW/cm2 (milliwatts / square cm) display range: 0-999,999 mJ/cm2 (mJ / square cm) Power: AAA battery Electric power consumption: 100μA battery life: the normal operation of the use of one-year geometry: 140 mm diameter, 13 mm high Net weight: 450 grams of about ambient temperature: 0-45 degrees (Celsius ℃) instantaneous temperature: 110 (Celsius ℃) temperature can not be more than 10 seconds. Check the survey: As all of the electronics components, especially its light sensor, usually with time of aging, it is proposed to conduct a check for one year. And replace the battery, the check should also be investigated.